Drive

UV110-UFD5

  • ESD Prevention: Air discharge ±15KV; contact discharge ±8KV 
  • Adopts advanced LDPC ECC engine with 3D NAND flash memory to improve reliability
  • Global Wear Leveling
  • Flash bad-block management
  • 4K Page Mapping
  • Power Failure Management
  • S.M.A.R.T.
  • Hyper Cache Technology
  • SMART Read Refresh™

Industrial USB: UV110-UFD5

Apacer’s UV110-UFD5 utilizes 3D NAND for higher capacity up to 256GB, provides more power efficiency than 2D NAND and enhances environment and ESD protection, with the aim of replacing a conventional IDE hard disk drive.

UV110-UFD5 is a new generation USB flash drive compatible with the latest USB specification – USB 3.1 Gen1 Super Speed, with a maximum transfer rate of 5.0 Gb/s. The connector is backward compatible with USB 2.0 and USB 1.1 interfaces. With compliance with USB 3.1 specification, this USB drive can deliver up to 255 MB/s outstanding performance.

Reliability wise, UV110-UFD5 is implemented with LDPC (Low Density Parity Check) ECC engine to extend SSD endurance and increase data reliability while reading raw data inside a flash chip. In addition, the drive comes with various implementations including powerful hardware ECC engine, Wear Leveling, flash block management, S.M.A.R.T., Page Mapping, etc. This product is well suited for portable flash storage applications while operating at minimal power consumption.

Spec

OPEN
  • Model UV110-UFD5
  • Interface USB 3.1 Gen1
  • Connector USB Type A Plug
  • Form Factor USB flash drive
  • NAND Flash Type 3D TLC
  • Capacity 64GB~256GB
  • External DRAM No
  • Sustained Read Performance (MB/sec) Up to 255
  • Sustained Write Performance (MB/sec) Up to 120
  • ECC Engine Low-Density Parity-Check (LDPC) Code
  • IOPS (4K Random Write) 900
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Extended Operating Temperature ( °C ) -40 ~ + 85
  • Storage Temperature ( °C ) -40 ~ + 100
  • Housing Yes
  • H/W Write Protect No
  • Screw Hole No
  • Cable-less Solution No
  • Thermal Sensor No
  • Shock Operation: 50G/11ms
    (compliant with MIL-STD-202G)
    Non-operation: 1500G/0.5ms
    (compliant with MIL-STD-883K)
  • Vibration Operation: 7.69 Grms, 20~2000 Hz/random
    (compliant with MIL-STD-810G)
    Non-operation: 4.02 Grms, 15~2000 Hz/random
    (compliant with MIL-STD-810G)
  • Operating Voltage 5.0 V ± 5%
  • Power Consumption Active mode: 205 mA; Idle mode: 75 mA
  • Dimension (L x W x H ) 56.05 x 18.00 x 8.5 (mm)
  • MTBF (hours) >3,000,000
  • Technology Bidirectional Security Identification / ESD Protection / Page Mapping / S.M.A.R.T. / Smart Read Refresh™ / Wide Temperature
  • Application Defense / Gaming / Healthcare / Server & Networking

Downloads

OPEN
  • eDM UV110-UFD5 935.54 KB