Drive

UT110-UFD2

  • Adopts advanced LDPC ECC engine with 3D NAND flash memory to improve reliability
  • Global Wear Leveling
  • Flash bad-block management
  • Page Mapping
  • Power Failure Management
  • S.M.A.R.T.
  • Hyper Cache Technology
  • SMART Read Refresh™ 

Industrial USB: UT110-UFD2

Apacer’s UT110-UFD2 utilizes 3D NAND for higher capacity up to 64 GB and provides more power efficiency than 2D NAND, with the aim of replacing a conventional IDE hard disk drive.

UT110-UFD2 is a new generation USB flash drive compatible with the latest USB specification – USB 3.1 Gen1 (SuperSpeed), with a maximum transfer rate of 5.0 Gbps. The connector is backward compatible with USB 2.0 and USB 1.1 interfaces. With compliance with USB 3.1 specification, this USB drive can deliver up to 255 MB/s outstanding performance.

UT110-UFD2 is built with the highest durability and ruggedness with a special Chip-On-Board (COB) packaging technology, which allows your precious files to be safely stored and protected against dust, water and shock at all times.

Reliability wise, UT110-UFD2 is implemented with LDPC (Low Density Parity Check) ECC engine to extend SSD endurance and increase data reliability while reading raw data inside a flash chip. In addition, the drive comes with various implementations including powerful hardware ECC engine, Wear Leveling , flash block management, S.M.A.R.T., Page Mapping,etc. This product is well suited for portable flash storage applications while operating at minimal power consumption.

Spec

OPEN
  • Model UT110-UFD2
  • Interface USB 3.1 Gen1
  • Connector USB Type A Plug
  • Form Factor USB flash drive
  • NAND Flash Type 3D TLC
  • Capacity 32GB~64GB
  • External DRAM No
  • Sustained Read Performance (MB/sec) Up to 250
  • Sustained Write Performance (MB/sec) Up to 100
  • ECC Engine Low-Density Parity-Check (LDPC) Code
  • IOPS (4K Random Write) 600
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Storage Temperature ( °C ) -40 ~ 100
  • Housing Yes
  • H/W Write Protect No
  • Screw Hole No
  • Cable-less Solution No
  • Thermal Sensor No
  • Shock Operation: 50G/11ms
    (compliant with MIL-STD-202G)
    Non-operation: 1500G/0.5ms
    (compliant with MIL-STD-883K)
  • Vibration Operation: 7.69 Grms, 20~2000 Hz/random
    (compliant with MIL-STD-810G)
    Non-operation: 4.02 Grms, 15~2000 Hz/random
    (compliant with MIL-STD-810G)
  • Operating Voltage 5.0 V ± 5%
  • Power Consumption Active mode: 130 mA; Idle mode: 45 mA
  • Dimension (L x W x H ) 23.10 mm x 14.25 mm x 6.90 mm
  • MTBF (hours) >3,000,000
  • Technology Page Mapping / S.M.A.R.T. / Smart Read Refresh / Thermal-Shock
  • Application Defense / Gaming / Server & Networking

Downloads

OPEN
  • eDM UT110-UFD2 1.32 MB