Module

UDMII Plus LP 180D (Type D) (H)

  • Built-in hardware ECC
  • Global wear-leveling 
  • Flash bad-block management
  • S.M.A.R.T.
  • connector designed with latch locking 

Introduction

Apacer’s USB-Disk Module (UDM) II Plus is a USB2.0 high speed flash storage designed to replace a conventional IDE hard disk drive. UDMII Plus LP 180D coming with both w/o houing and with house can be plugged into a standard Embedded USB connector commonly found in desktops, portable PC systems and industrial PC systems. This product is well suited for embedded flash storage applications offering new and expanded functionality as well as more cost-effective designs, better performance and increased reliability.

Spec

OPEN
  • Model UDMII Plus LP 180D (Type D) (H)
  • Interface USB 2.0
  • Connector 10 pin USB (2x5) female header in 2.54mm
  • Form Factor USB Disk Module
  • NAND Flash Type SLC
  • Capacity 256MB~32G
  • Sustained Read Performance (MB/sec) Up to 34
  • Sustained Write Performance (MB/sec) Up to 22
  • ECC Engine Built-in 24-bit per 1K bytes BCH ECC
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Extended Operating Temperature ( °C ) -40 ~ + 85
  • Storage Temperature ( °C ) -40 ~ + 100
  • Housing Optional
  • H/W Write Protect Optional
  • Shock Half sine wave 50G, 6 axes, 18 times
    (IEC 68-2-27, non-operating)
  • Vibration Sine wave 10 Hz to 500 Hz, 50 m/s2 , 3 axes
    (IEC 68-2-6, non-operating)
  • Operating Voltage 5V ± 5%
  • Power Consumption Active mode: 181 mA & Idle mode: 68 mA
  • Dimension (L x W x H ) Without Housing: 33.65 x 24.00 x 7.00 (mm)
    With Housing: 35.70 x 28.10 x 7.20 (mm)
  • MTBF (hours) >2,000,000
  • Technology S.M.A.R.T. / Wide Temperature
  • Application Healthcare / Server & Networking

Downloads

OPEN
  • eDM UDMII Plus LP 180D (Type D) (H) 1.36 MB