CFast
SV25P-CFast
- Low-Density Parity-Check (LDPC) Code
- Global Wear Leveling
- Flash bad-block management
- Flash Translation Layer: Page Mapping
- S.M.A.R.T.
- Device Sleep
- ATA Secure Erase
- TRIM Support
- Hyper Cache Technology
- Over-provisioning
- DataRAID™
- SMART Read Refresh™
Introduction
Apacer SV25P-CFast 2.0, utilizing 3D NAND for higher capacity up to 960GB and providing more power efficiency than 2D NAND, is the latest enhancement of conventional CFast form factor that delivers various technological advantages. This new flash memory card comes with SATA 6 Gb/s interface for exceptional performance with data transfer rates up to 560 MB/s in sequential access and 69,000 IOPS in 4KB random access, and consists of SATA-based 7-pin signal segment and 17-pin for power and control purposes. Designed without DRAM on the internal controlling unit, SV25P-CFast 2.0 ensures data integrity by preventing data loss during a sudden power outage.
SV25P-CFast 2.0 guarantees reliability of applications in harsh environments by implementing intelligent Flash Management algorithms and LDPC (Low Density Parity Check) ECC engine to extend SSD endurance and increase data reliability. Furthermore, SV25P-CFast 2.0 is equipped with a built-in thermal sensor to monitor the temperature of the SSD via S.M.A.R.T commands to prevent overheating. Operating under 6 Gb/s interface, SV25P-CFast 2.0 is provided with Apacer latest S.M.A.R.T. that is primarily oriented for the latest SATA interface SSD, for drive lifetime monitoring and analysis. For highly-intensive applications, End-to-End Data Protection ensures that data integrity can be assured at multiple points in the path to enable reliable delivery of data transfers.
Spec
OPEN- Model SV25P-CFast
- Interface SATA 3.2 (6Gb/s)
- Connector 7 + 17 pin female connector
- Form Factor CFast
- NAND Flash Type 3D TLC
- Capacity 120-960GB
- External DRAM No
- Sequential Read Performance (MB/sec) Up to 560
- Sequential Write Performance (MB/sec) Up to 495
- ECC Engine Low-Density Parity-Check (LDPC) Code
- IOPS (4K Random Write) 69K
- Standard Operating Temperature ( °C ) 0°C to 70°C
- Extended Operating Temperature ( °C ) -40°C to 85°C
- Storage Temperature ( °C ) -55°C to 100°C
- Housing Yes
- Thermal Sensor Yes
-
Shock
Operation: 50G/11ms
(compliant with MIL-STD-202G)
Non-operation: 1500G/0.5ms
(compliant with MIL-STD-883K) -
Vibration
Operation: 7.69 Grms, 20~2000 Hz/random
(compliant with MIL-STD-810G)
Non-operation: 4.02 Grms, 15 ~ 2000 Hz/sine
(compliant with MIL-STD-810G) - Operating Voltage 3.3 V ± 5%
- Power Consumption Active mode: 385 mA / Idle mode: 75 mA
- Dimension (L x W x H ) 42.80 mmx 36.45 mm x 3.60 mm
- MTBF (hours) >3,000,000
- Technology AES 256-bit Encryption / ATA Secure Erase / CorePower / DataRAID™ / DEVSLP / End-to-end Data Protection / Over-provisioning / Page Mapping / S.M.A.R.T. / Smart Read Refresh™ / SSDWidget 2.0 / Thermal Sensor / Wide Temperature / Write Protect
- Application Factory Automation / Gaming / Healthcare / Internet of Things / Server & Networking / Transportation