microSD
Industrial microSD H1-SL
- Compliant with SD 3.0 Specification
- S.M.A.R.T Supported
- Support SD Mode and SPI Mode
- Wear-leveling and Block Management
- Support Class 10 with UHS-I
- SLC-lite Technology
- Low Power Consumption
- Auto Read Refresh
- Power Failure Management
Introduction
Apacer Industrial microSD H1-SL series conforming to SD3.0 specification supports speed class up to U3 through UHS-I. The microSD H1-SL 3.0 card bulit with MLC NAND Flash is capable of delivering better performance by the latest firmware architecture including a powerful built-in Error Correction, Read Retry , Wear-leveling and Bad Block Management algorithms.
Furthermore, with Apacer’s SLC-lite technology, it performs with an outstanding number of P/E cycles up to 20,000 , but lower cost than SLC. This product is well suited for portable flash storage applications while operating at minimal power consumption.
Spec
OPEN-
Model
Industrial microSD H1-SL
- Interface SD 3.0
-
Form Factor
microSD
- NAND Flash Type MLC
-
Capacity
4G~32G
-
Sequential Read Performance (MB/sec)
Up to 43
-
Sequential Write Performance (MB/sec)
Up to 40
-
ECC Engine
Built-in 42-bit per 1K bytes BCH ECC
-
Standard Operating Temperature ( °C )
-25 ~ + 85
-
Extended Operating Temperature ( °C )
-40 ~ + 85
-
Storage Temperature ( °C )
-40 ~ + 85
-
Shock
(Operating)1,500G, 0.5ms
-
Vibration
20Hz~80Hz/1.52mm (frequency/displacement)
80Hz~2,000Hz/20G (frequency/accelerate)
-
Operating Voltage
2.7V ~ 3.6V
-
Power Consumption
Active mode: 140mA & Idle mode: 245 uA
-
Dimension (L x W x H )
15x11x1 (mm)
-
MTBF (hours)
>3,000,000
- Technology Content Pre-load / Page Mapping / SLC-lite / S.M.A.R.T. / Wide Temperature / Write Protect
- Application Gaming / Healthcare / Server & Networking / Transportation