CFast
CFast 2
- Compliant with CFast 2.0 specifications
- Built-in ATA Secure Erase and S.M.A.R.T. Functions
- Advanced wear-leveling and Block Management
- Intelligent Power Failure Recovery
- DEVSLP Support
- HW Write-Protect Switch (Optional)
Introduction
Since CompactFlash Association released the specification of CFast 2.0, Apacer takes the lead to roll out the first industrial-grade SATA 3.0 (6Gb/s) high-speed transmission interface CFast 2.0 memory card around the globe. Its sequential speed is up to 285/260 MB/sec and dimension is 42.8mm x 36.4mm x 3.6mm with (7+17) pin connector. Besides featuring a 2-Channel bidirectional structure, the CFast 2.0 adopts Toggle DDR 2.0 NAND Flash, which brings its performance to a higher level. Support for DEVSLP (Device Sleep) power mode enables them to switch into a low power state on standby mode so as to save power for companies.
Spec
OPEN- Model CFast 2
- Interface SATA 3.0 (6Gb/s)
- Connector (7+17) pin male
- Form Factor CFast
- NAND Flash Type SLC
- Capacity 4GB~64GB
- External DRAM NA
- Sequential Read Performance (MB/sec) Up to 285
- Sequential Write Performance (MB/sec) Up to 260
- ECC Engine Built-in 40-bit per 1K bytes BCH ECC
- Standard Operating Temperature ( °C ) 0 ~ + 70
- Extended Operating Temperature ( °C ) -40 ~ + 85
- Storage Temperature ( °C ) -40 ~ + 100
- H/W Write Protect Optional
- Thermal Sensor Optional
- Shock 50G (complied with MIL-STD810)
- Vibration 15G (complied with MIL-STD810)
- Operating Voltage 3.3 V ± 5%
- Power Consumption Active mode: 500 mA & Idle mode: 90 mA
- Dimension (L x W x H ) 42.8 x 36.4 x 3.6 (mm)
- MTBF (hours) >2,000,000
- Technology Content Pre-load / Erase / S.M.A.R.T. / Thermal Sensor / Wide Temperature / Write Protect
- Application Defense / Gaming / Healthcare / Server & Networking / Transportation