2.5" SSD Drive

SFD25H1-M

  • Advanced 4K Page Mapping Technology
  • Wide Temperature support
  • Built-in ATA Secure Erase and S.M.A.R.T. Functions
  • Intelligent Power Failure Recovery
  • DEVSLP Support (Optional)
  • 7mm Housing
     

Introduction

Apacer SFD25H1-M 2.5” SATA SSD delivers all the advantages of flash disk technology with Serial ATA 6.0 Gbps interface, including being fully compliant with standard 2.5-inch form factor, providing low power consumption compared to traditional hard drive and hot-swapping when removing/replacing/upgrading flash disks. The device is designed for Embedded and IPC systems required high performance and reliability.

Spec

OPEN
  • Model SFD25H1-M
  • Interface SATA 3.0 (6Gb/s)
  • Connector (7+15) pin male
  • Form Factor 2.5
  • NAND Flash Type MLC
  • Capacity 8GB~256GB
  • External DRAM No
  • Sustained Read Performance (MB/sec) Up to 430
  • Sustained Write Performance (MB/sec) Up to 190
  • ECC Engine Built-in 72-bit per 1K bytes BCH ECC
  • IOPs (4K Random Write) 22K
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Extended Operating Temperature ( °C ) -40 ~ + 85
  • Storage Temperature ( °C ) -40 ~ + 85
  • Thermal Sensor No
  • Shock Operation: 50G, 11ms
    Non-operation: 1500G, 0.5ms
  • Vibration Operation: 7.69 Grms, 20~2000 Hz/random
    (compliant with MIL-STD-810G)
    Non-operation: 15 G, 10 ~ 2000 Hz/sine
  • Operating Voltage 5.0 V ± 5%
  • Power Consumption Active mode: 320 mA & Idle mode: 75 mA
  • Dimension (L x W x H ) 100 x 69.8 x 7 (mm)
  • MTBF (hours) >1,000,000
  • Technology Page Mapping / SSDWidget / Wide Temperature / S.M.A.R.T. / Content Pre-load
  • Application Transportation / Embedded & IPC / Gaming

Downloads

OPEN
  • eDM SFD25H1-M 1.01 MB