HalfSlim (MO-297)

SFD18SH-M

  • Compliant with JEDEC MO-297 standard
  • Global Wear-leveling and Block Management
  • Built-in ATA Secure Erase and S.M.A.R.T. Functions
  • TRIM Command Support
  • DEVSLP Support
  • Power Failure Management
     

Introduction

Apacer SFD18SH-M half-slim MO-297 SSD (Solid State Drive) delivers multiple technological advantages of flash memory storage. With SATA 6.0 Gbps interface, SFD18SH-M offers exceptional data transfer performance. Form factor wise, this model is fully compliant with JEDEC MO-297 standard, which is designed with standard interface consisting of SATA 7-pin signal segment and 15-pin power segment, while in compact size. This module provides low power consumption compared to traditional hard drive and hot-swapping when removing/ replacing/ upgrading flash disks. Its capacity could provide a wide range up to 256 GB. Moreover, it can reach up to 430MB/s read as well as 160MB/s write high performance.

Spec

OPEN
  • Model SFD18SH-M
  • Interface SATA 3.0 (6Gb/s)
  • Connector (7+15) pin male
  • Form Factor JEDEC (MO297)
  • NAND Flash Type MLC
  • Capacity 8GB~256GB
  • External DRAM No
  • Sustained Read Performance (MB/sec) Up to 430
  • Sustained Write Performance (MB/sec) Up to 160
  • ECC Engine Built-in 72-bit per 1K bytes BCH ECC
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Extended Operating Temperature ( °C ) -40 ~ + 85
  • Storage Temperature ( °C ) -40 ~ + 85
  • Thermal Sensor Optional
  • Shock 1500G (complied with MIL-STD810)
  • Vibration 15G (complied with MIL-STD810)
  • Operating Voltage 5.0 V ± 5%
  • Power Consumption Active mode: 340 mA & Idle mode: 75 mA
  • Dimension (L x W x H ) 54 x 39.8 x 4 (mm)
  • MTBF (hours) >1,000,000
  • Technology Page Mapping / Wide Temperature / Thermal Sensor / S.M.A.R.T. / DEVSLP / Content Pre-load / Erase
  • Application Cloud Computing / Transportation / Embedded & IPC / Military / Healthcare

Downloads

OPEN
  • eDM SFD18SH-M 4.81 MB