SSD Module

SDM5 7P/180D LP2

  • 7-pin SATA connector
  • Unique Hook Design
  • Power Cable-less Solution
  • Perfect Solution for 1U System
  • TRIM Command Support
  • Write Protect by hardware switch (optional)
  • Built-in ATA Secure Erase and S.M.A.R.T. Functions
  • Global Wear-Leveling and Block Management

Introduction

Apacer’s SDM5 (SATA Disk Module 5) 7P/90D LP2 offers elevated speed boost and higher error correction capabilities. Built with SATA 6.0 Gb/s interface, SDM5 delivers high performance and wide compatibility.

With its SATA interface compliance and compact size, this high-speed disk module defines an ideal balance of performance, capacities, reliability and cost. SDM5 is suitable in industrial applications and light operating systems for specific operations. The architectural nature of SATA disk module provides higher resistance to external environmental influences and better flexibility for motherboard space.

Regarding data reliability, SDM5 is built in with powerful ECC engine that can correct up to 40-bit per 1KB data. In addition, the controller unit of this DOM device supports wear-leveling, SMART and power failure management for data integrity. With its trustable reliability, performance and cost effectiveness, Apacer’s SDM5 is definitely the ideal storage or cache solution for embedded and industrial computers, servers and thin clients.

Spec

OPEN
  • Model SDM5 7P/180D LP2
  • Interface SATA 3.0 (6Gb/s)
  • Connector 7-pin
  • Form Factor SATA Disk Module
  • NAND Flash Type SLC
  • Capacity 8GB~32GB
  • External DRAM No
  • Sustained Read Performance (MB/sec) Up to 435
  • Sustained Write Performance (MB/sec) Up to 215
  • ECC Engine 40 bit/ 1K Bytes
  • Standard Operating Temperature ( °C ) 0 ~ + 70
  • Extended Operating Temperature ( °C ) -40 ~ + 85
  • Storage Temperature ( °C ) -40 ~ + 100
  • Housing No
  • H/W Write Protect No
  • Screw Hole No
  • Cable-less Solution Optional (7+2 pin)
  • Shock Operation: 50G, 11ms
    Non-operation: 1500G, 0.5ms
  • Vibration Operation: 7.69 Grms, 20~2000 Hz/random (compliant with MIL-STD-810G)
    Non-operation: 15 Grms, 10 ~ 2000 Hz/sine
  • Operating Voltage 5.0 V±5%
  • Power Consumption Active mode: 260 mA & Idle mode: 60 mA
  • Dimension (L x W x H ) 33.0 x 29.3 x 8.85 (mm)
  • MTBF (hours) >2,000,000
  • Technology Page Mapping / Power Cable-less / Wide Temperature / S.M.A.R.T. / Content Pre-load / Write Protect
  • Application Transportation / Embedded & IPC / Military / Gaming

Downloads

OPEN
  • eDM SDM5 7P 180D LP2 1.17 MB